Back to Decals Home  
 

With our growing range of decals we have started stocking some complimentary products. As with most categories this one will grow with time as we get asked for more items.

   
 
Sol Micro Sol setting solution
"Micro Sol setting solution is for the most difficult irregular surfaces you find on models. It completely softens the Microscale Decal allowing it to drape down onto the surface of the model conforming perfectly and without distortion. You can get the most amazing results in seemingly impossible places, because Micro Sol actually makes the decal part of the paint. For that reason you should coat Micro Sol on for only a few seconds and then leave it alone, it does the work. Do not touch until dry as the decal is very soft at this stage and could be easily damaged. "

Micro-Set Decal Solvent Micro Set Decal setting solution

"Micro Set is a very versatile decal setting solution that does several things to the Microscale Decals to improve application. Micro Set should be applied to the surface of the model where you will be sliding off the decal. Micro Set prepares the surface with special wetting agents that cuts the oils in new paint and converts the adhesive on the back of the decal to a stronger and more lasting one. And finally, Micro Set slightly softens the decals film to make it more flexible so that it can conform better to the model's surface. Better adhesion by the decal to the model prevents tiny air bells from occurring and results in an invisible carrier film or the so called 'painted on look'. "


MicroScale Clear Decal Film


If this is ordered on its own shipping will be adjusted to 2.50 before your card is charged

Transparent decal paper (trimfilm) if you cannot see the colour that you want you can spray paint any trimfilm any colour

This is ideal for doing your own lining for those difficult to get into places on an loco. Spray the decal sheet with the body colour at the same time as you do the model. Then rule or paint your lining on to this sheet. When its all dry cut as close to the line, soak in water and slide it on to the model. When its just where you want it pad it dry to set it in place.

Finish off with the softening and setting solutions to really bed it down and then varnish over it to seal it




 

 

Back to Decals Home